vasupte.blogg.se

Gateway m-6846 disassembly
Gateway m-6846 disassembly






gateway m-6846 disassembly

Unplug the speaker cable (left) and the Bluetooth card cable (right) from the system board. Remove five screws securing the motherboard. Lift up and remove the top cover assembly. Unplug the touch pad cable from the system board. Remove four screws securing the top cover.

gateway m-6846 disassembly

Remove two screws from each display hinge.Ĭarefully lift up and remove the LCD assembly. Release the wireless card antenna cables. Release the cable and remove the keyboard. Lift up the keyboard as it shown on the picture below and place it upside down on the palm rest. Start removing the hinge cover with a small flathead screwdriver and continue removing it with your fingers. If you are replacing the keyboard, you simply remove one green screw in the step 1 and two green screws in the step 5 and then proceed to steps 7,8,9,10. Two screws marked with green circles are securing the keyboard. Push the drive to the right and remove it. Remove one screw securing the CD/DVD drive. Loosen four screws securing the heat sink assembly (red circles).Ĭarefully lift up the heat sink assembly and separate it from the motherboard.ĭisconnect the cooling fan cable from the motherboard. Remove one screw securing the wireless card and remove the card. In order to disconnect the hard drive from the motherboard, you’ll have to slide it assembly to the left, lift up and remove.ĭisconnect two antenna cables from the wireless card, simply unsnap them from the card using your fingers. Remove two screws (red circle) securing the hard drive. Remove one screw (orange circle) securing the Wi-Fi card cover. There are two more keyboard screws under the memory cover. Remove one screw (yellow circle) securing the keyboard. Remove seven screws (yellow circles) securing the memory cover. Turn off the computer, unplug the AC adapter and remove the battery. I’ll be removing the system board so I can access and repair the jack. Apparently, there is a problem with the power socket (DC jack) and it has to be replaced or resoldered. In order to charge it I have to adjust the AC adapter plug inside the power socket on the back of the laptop. In my case the battery started charging intermittently with the AC adapter connected. Please cycle your Power Bank by fully charge and discharge it for 3~5 times to allow it to reach its maximum rated capacity before use.I think my disassembly instructions will work for other Gateway NX570 models too. Note: New Power Bank is normally shipped in its partially charged condition. Children must not play unsupervised near the product and its connections.

  • Always keep the battery pack out of the reach of infants and children.
  • Remove your clothes that have been contaminated by the electrolytic substance and wash them with a synthetic detergent immediately.
  • If there is leakage of electrolytic substance from the battery pack, use large amount of water to wash off any liquid tainting any part of the body immediately.
  • If unpleasant smell is detected and deforming casing occurred during charging, turn off the power supply immediately and unplug the power cord from AC wall-socket to avoid possible damage or risk (e.g.
  • Stop charging the battery immediately if charging does not complete in reasonable time.
  • During charging, the temperature of the battery pack will rise slightly.
  • Charge this battery pack at least once every 3 months if you do not use it for a long time.
  • no irritating chemicals, detergents or cleaning agents with relatively high density.
  • To clean the battery pack, use only soft cloth with mild soap solution containing no harmful substances, i.e.
  • Disconnect the power supply before cleaning the battery pack.
  • Do not dispose this product together with household waste.
  • Dispose the battery pack and its accessories in strict accordance with local environmental protection laws and regulations, e.g.
  • Keep the battery pack at room temperature in a dry place.
  • Do not place the battery pack in the vicinity of inflammable, explosive and dangerous objects and corrosive materials.
  • radiators and other electrical devices, and chimney, etc.

    gateway m-6846 disassembly

  • Do not expose the battery pack to direct sunlight and other heat sources, e.g.
  • Do not disassemble, refit or reassemble the Power Bank (battery pack).
  • Reminder: Please fully charge the Power Bank prior to the first use. This Power Bank can provide power supply to devices with different voltages at the same time.








    Gateway m-6846 disassembly